Denon DVD-2930CI - Manual (Page 26)

ENGLISH
ENGLISH
Making the initial settings Making the initial settings
23
Use [D D H H] to select the item to be set, then press
[ENTER] .
2
Use [D D H H] to select “DIGITAL OUTPUT”, then press
[ENTER] .
1
NORMAL (Upon purchase):
Select this when an AV amplifier with built-in Dolby Digital or DTS
decoder is connected to the DVD-2930CI’s digital audio output
terminal.
When playing discs recorded in Dolby Digital or DTS, the
corresponding bitstream signals are output.
Use this procedure to set the signal format of the digital audio output.
PCM:
When playing discs recorded in Dolby Digital or DTS, the signals are
converted to 48 kHz/16 bit PCM (2-channel) before being output.
1
2
Use [D D H H] to select the item to be set, then press
[ENTER] .
2
Use [D D H H] to select “DOWN SAMPLING”, then
press [ENTER] .
1
OFF (Upon purchase):
For DVDs recorded in linear PCM or packed PCM without copyright
protection, 2-channel audio signals of up to 96 kHz are output as
linear PCM signals with no conversion. (192 kHz and 176.4 kHz
signals are converted to 96 kHz and 88.2 kHz, respectively.)
ON:
Linear PCM or packed PCM signals are converted to 48 kHz or less
for output.
Set to “ON” when using digital connections to an AV amplifier
that is not compatible with sampling frequencies of 192 kHz,
176.4 kHz, 96 kHz and 88.2 kHz.
1
2
Digital output
Use this procedure to set the digital audio output when playing DVDs
recorded in linear PCM or packed PCM.
Downsampling
• For DVDs containing multi-channel PCM signals, the signals are
down-mixed into the 2-channels and output in digital format. (For
sources for which down-mixing is prohibited, only the FL and FR
channels are output.)
• When playing linear PCM or packed PCM DVDs with copyright
protection, due to considerations for the copyright holder, digital
output is not possible for sources of 48 kHz/16 bit or more.
To play such sources, either set to “ON”, use DENON LINK or
analog connections (
page 9, 10).
• When playing discs recorded in linear PCM or packed PCM, the
signals are output in linear PCM format, regardless of this setting.
Use [D D H H] to select the item to be set, then press
[ENTER] .
2
Use [D D H H] to select “SOURCE DIRECT”, then press
[ENTER] .
1
OFF (Upon purchase):
Select this when playing using the “SPEAKER SETUP” and “BASS
ENHANCER” settings.
Use this procedure to making the setting for direct audio output of the
disc’s data without making the “SPEAKER SETUP” settings at
“AUDIO CHANNEL”.
Making this setting allows you to enjoy full-band playback of all
channels, as recommended for DTS. (Note that this setting increases
the volume of the subwoofer by 5 dB, or 15 dB for Super Audio CDs.)
This setting also lets you enjoy playback of 6-channel DVD-Audio
sources recorded in full frequency band for all channels.
1
50kHz, 100kHz:
When playing Super Audio CDs, frequencies higher that these
respective frequencies are cut.
Set to “100kHz” when using an amplifier compatible with high
frequencies.
2
Source direct