Campomatic AC12MP - Manual (Page 10)

OPERATING INSTRUCTIONS
8
FOLLOW ME operation(on some models)
This feature can be activated from the
remote control ONLY. The remote
control serves as a remote thermostat
allowing for the precise temperature
control at its location.
To activate the Follow Me feature, point
the remote control towards the unit and
press the Follow Me button. The light on
the unit control panel will illuminate to
indicate it received the signal.It will
continue to send this signal until the
feature is deactivated by pressing the
Follow Me button again. If the unit does
not receive the Follow Me signal during
any 7 minutes interval, the unit will beep
to indicate the Follow Me mode has en
ded. The display on the remote control
indicates the temperature at the remote
To activate the ION operation ,the anion
generator is energized and will help to
remove pollen and impurities from the air.
ION operation(on some models)
This feature can be activated from the
remote control ONLY.
SLEEP operation
Press this button, the set temperature will increase
O O (cooling) or decrease(heating) by 1 C/2 F in 30
minutes.The set temperature will then increase
O O (cooling) or decrease (heating) by another 1 C/2 F
after an additional 30 minutes. This new temper-
ature will be maintained for 7 hours before it returns
to the originally selected temperature. This ends
the Sleep mode and the unit will continue to ope-
rate as originally programmed.
NOTE: This feature is unavailabe under FAN or
DRY mode.
Auto sliding panel slide down automatically
Fig.5a
Auto sliding panel slide up automatically
Fig.5b
Danger !Do not put
fingers here.
ONLY.
Swing automatically
Fig.6
Other features
In the case of a power outage or interruption,
the unit will auto matically re-start, in the
settings as used, after the power is restored.
Power Outage
After the unit has stopped, it can not be restarted
operation in the first 3 minutes. This is to protect
the unit. Operation will automatically start after
3 minutes.
Wait 3 minutes before resuming operation
The louver can be adjusted automatically .
Adjust the air flow direction automatically
(Fig.6):
When the Power is ON, the louver opens fully.
Press the SWING button on the panel or
remote controller to initiate the Auto swing
feature.
The louver willl swing up and down
automatically.
- Please do not adjust the louver manually.
Air flow direction adjustment
LOCK operation
Press and hold the SWING and MODE buttons
simultanuously for 3 seconds will lock the panel.
It will not slide even the machine is turned off.
NOTE: This machine is specially designed with an
auto sliding panel. When the unit turns on, it will slide
down automatically.And the air outlet is open(See Fig.5a)
.When the unit turns off, the panel slides up automatically
and this may cause about 50-80N strengh(See Fig.5b) .
Please pay attention do not put the fingers on the
air outlet when the unit turns off and ensure children
do not operate or play with the machine.
WARNING