Burst Electronics F2B - Manual (Page 5)

Power is supplied by a 12 Vdc 500 mA wall module
(included). Any 12 Vdc source may be used
(camera battery pack or equivalent). The center pin
for the power supply is negative.
VMF-2 Operation
The VMF-2 will fade from A to B, B to A, or A to
Black. The operation can be done manually via the
RCU’s fader bar or automatically via the
TAKE
pushbutton or remote GPI trigger.
A to B, B to A Fade
Preset the fader bar to A. Select
MANUAL Mode with
the top pushbutton of the RCU, the Red LED will be
on, indicating manual operation. Also, select
A TO B
on the
MODE switch of the RCU, the Green LED will
be on. Sliding the fader bar will now fade from
channel A to channel B, and from channel B to
channel A.
A to Black
Preset the fader bar to A. Select
A TO BLK on the
MODE switch, the Red LED is on. Operation of the
fader bar will now fade channel A to Black, and from
Black to A. This operation strips the active video
from the signal leaving behind the sync, color burst
and black. No B input is required for A to Black
operation.
Take Mode
Select
AUTO on the MODE switch. The speed of the
TAKE is now controlled by the position of the fader
Video Mixers & Faders 3