Pin programming – Directed Electronics 750 User Manual
Page 33
30
pin programming
A PIN code can have one to four digits; each digit can be from 0-9.
Programming Procedure
1.
Enter the feature location in the installer programming grid.
2.
Immediately press and release
of the PlainView 2 Valet button.
3.
Select each digit by pressing
1-9 times, and then press
to enter the number into the system. To enter a zero,
press only.
4.
Wait for two siren chirps after a five second pause or five
seconds after the last digit has been entered if using less
than four digit code number.
5.
Turn off the ignition; the siren will chirp three times.
6.
The programming mode is now exited.
To program a PIN code of 1032:
1.
Press and release
once and
once. You will
hear one chirp.
3.
Press and release
once. You will not hear a chirp
after programming a zero.
5.
Press and release
three times, and then press
once. You will hear three chirps.
6.
Press and release
two times, and then press
once. You will hear two chirps.
nnoottee:: A PIN code cannot begin with a zero.