12 ..... safety 12 ..... technical specifications – BUG-O Systems SPB-3000 User Manual
Page 12
12
GENERAL SAFETY
1.
The operator should read the instruction manual and be properly trained in industrial safety.
2.
Only use the beveling machine as stated in the instruction manual.
3.
Do not use beveling machine if it is missing parts, or fitted with non-original spare parts.
4.
Do not use the beveling machine if the power supply parameters do not match the
nameplate specifications.
5.
Inspect the beveling machine with attention to condition of the power cable, control
elements and machining tools (inserts) .
6.
Power connection must be supplied with protection circuit (grounding).
7.
Do not operate the beveling machine in the presence of unauthorized persons.
DETAILED SAFETY
1.
Before operation, inspect electrical system condition, including power cord and plug.
2.
The beveling machine must be connected to an electrical system with neutral or ground
circuit and protected by a 16A fuse for the 220V supply. On a construction site, power must
be supplied from a separating transformer with class II insulation.
3.
Do not expose the beveling machine to rain or excessive moisture.
4.
The beveling machine is not rated for use in explosion hazard zones.
5.
Always wear proper eye and ear protection. Hand protection is also recommended.
6.
Do not remove metal chips with bare hands.
7.
Machining inserts in the milling head must be secured tight by screws.
8.
If machining insert is worn, rotate insert in its seat by 90° or replace.
9.
Use proper tools, as specified in the instruction manual.
10.
Upon completing work, always clean the beveling machine to remove metal chips.
11.
Always disconnect the power cable before performing maintenance.
TECHNICAL SPECIFICATIONS
Power supply ……………………………………………….230-240 VAC
Power consumption ………………………………………..1.5 kW
Bevelling angles ……………………………………………0°, 22.5°,37.5°,45° *
* Other angles in 0-60
°
range on request.
Max. beveling width (face) and depth of cut depending on angle
ß
0°*
22.5°
30°
37.5°
45°
75° **
b (mm)
35
37
29
27
26
35
b (in)
1.38
1.45
1.14
1.06
1.02
1.38
c (mm)
35
34
26
21
18
13
c (in)
1.38
1.34
1.02
0.83
0.71
0.51
*Angle 0
°
enables to level sheet front, e.g. after oxy-acetylene cutting.
**Angle 75
°
available with optional equipment.
Working feed speed (for steel) - up to 400 mm/min
SAFETY