BUG-O Systems BEAM BUG III - Manual (Page 10)

10 15
ELECTRICAL COMPONENT CHART
BUG-1490 BUG-1492
120 VAC 240 VAC
1 Volt Trap BUG-1393 BUG-1563
2 Pilot Light BUG-1415 BUG-1428
2 Speed Nut BUG-1415-A BUG-1415-A
3 Circuit Breaker BUG-2923 BUG-2923
4 Power Cord BUG-9445 GOF-3115
5 Transformer BUG-9675 GOF-3112
6 Wiring Harness BUG-1467, BUG-1468
7 Speed Control BUG-1725
8 Potentiometer BUG-9686
9 Toggle Switch BUG-2255
10 Horiz. Drive Unit BUG-1463
11 Vert. Drive Unit BUG-1464
12 Vertical Limit Kit BUG-1221
ITEM DESCRIPTION
OPERATING INSTRUCTIONS (CONT’D.)
SQUARE CUTS
E. Depress Clutch Button (R) and move BEAM BUG III over web.
Swing torch vertical and position tip over cut in web, switch on
gases using the Quick Acting Manifold (S) and relight torch. When
preheat is adequate open Cutting Oxygen Valve (FF) [bat handle on
torch] and start travel in cut direction. Adjust speed to optimum. Stop
horizontal travel as close to flange as possible, and turn off gases
using Quick Acting Manifold (S) and Cutting Oxygen Valve (FF).
F. Swing torch to horizontal position (tip facing flange). Move BEAM
BUG III out beyond edge of flange and repeat Steps 2, 3 & 4.
8. We recommend the first flange cut to be on the magnet side of BEAM
RAIL.
Figure 4
Figure 5
Figure 6