BUG-O Systems CWP-11 - Manual (Page 6)

6
INTRODUCTION
The CWP-11 (CWP-1100) Programmable Circle Welder is designed for welding of nozzles
into vessels utilizing SUB-ARC, MIG or FLUX CORED PROCESS, with gas shielding. The
CWP-11 mounts on a 3-Jaw Chuck for welding diameter 6" to 50" O.D.
FEATURES
• Amperage & wire speed control.
• Wire feeder with one set of drive rolls.
• Wire sizes from 0.035 - 7/64 in (0.9 - 2.8 mm) for subarc welding.
• 1/12 HP P.M. motor and rotational speed control.
• 600 AMP gun & cable assembly.
• Gas shielding kit with 120 VAC solenoid valve.
• 5/8" (16 mm) gas cup.
• Burn back control.
• 50 ft. (15 m) power cable.
• 50 ft. (15 m) gas shielding hose.
• 50 ft. (15 m) weld cable.
• Quick disconnects for all cables.
• Weld contact switch.
• Cold wire inch switch.
• Wire direction switch.
• Pre and post flow controls.
• Wire reel adaptor for 60 lb. (27 kg) spools.
• Adjustable vertical and horizontal torch positioning system
• Microprocessor controlled rise and fall, up to 5" (125 mm).
• Brushes and collector rings for welding current, rated at 600 AMPS 100% duty cycle.
• Brushes and collector rings for all controls, eliminates cable and hose wrap.