BUG-O Systems CWP-11 - Manual (Page 44)

44
PREVENTIVE MAINTENANCE - DAILY
Refer to CWP-11 Exploded View. (Pg. 16)
Racking System Item #7:
Inspect gear rack, hardened ways and wheels (remove all dirt, grease, weld spatter and rust). Check hardened
ways for nicks and replace if necessary. Lubricate with a dry teflon or graphite spray lubricant. Adjust wheels for
snug fit and smooth operation. Lubricate racker pinion with a dry teflon or graphite spray lubricant.
Large Horizontal Racker Item #8:
Inspect wheels (remove all dirt, grease, weld spatter and rust). Adjust wheels for snug fit and smooth operation.
Lubricate racker pinion and wheels with a dry teflon or graphite spray lubricant.
Slide Bar Mounting Assembly Item #22:
Inspect hardened ways (remove all dirt, grease and weld spatter). Check hardened ways for nicks and replace if
necessary. Lubricate with a dry teflon or graphite spray lubricant.
Refer to CWP-11 Electrical Component Chart. (Pg. 31)
LN-9 Control Cables #11, 12, 13:
Inspect cable connector to make sure threads are not stripped and that the connector is not cracked. Check the
cable for cuts, missing insulation and burn spots, replace if necessary.
CWP-11 Collector Ring Item #3:
Inspect cable connector to make sure threads are not stripped and that the connector is not cracked. Ensure that
the connector is fastened properly to the large aluminum gear (item #29 on the CWP-11 Exploded View, pg. 16).
IMPORTANT:
Make sure the input power at the power source is turned off
and the 50' weld cable is disconnected from the circle welder
prior to working inside the circle welder!