BUG-O Systems Programmable Gantry System - Manual (Page 31)

31
Note:
1. Rail should be mounted on separate supports - not connected to burning bed
- so the rail alignment will not be disturbed during loading and unloading.
2. Rail must be straight and flat - parallel to cutting table.
SUGGESTED BED DESIGNS FOR BURNING TABLE
Actual Length
(Material Length
Plus 5'0" or more)
1/4" x 6" Bars
Centerline to Centerline
Distance. Maximum Work
Width plus 24"
Side Rails should be
3-4" below burning bed
Legs Grouted in
Concrete
ARR-O Rail
6" Wide Flange at
12 1b/FT
The construction of your burning table is very important. The table must be rigid and strong. 6" (150
mm) WF Beams are recommended for rail supports, so that even if they are not straight, the ARR-O
rails 4" wide (102 mm) may be mounted in a straight line. A transit is recommended for set-up, but
piano-wire can be used. The bolting holes in the rail are uniformly spaced, but rather than laying-out
the holes, position the rail on its supports and transfer the holes. Make sure that the rails on each
side start at the same place!