BUG-O Systems K-BUG 1200 - Manual (Page 8)

8
TIME SETTINGS
The K-BUG 1200 offers three adjustable time settings - Puddle Build-Up, Pause Time and Crater Fill.
The Travel Speed Adjustment knob is used for setting each of the timers, as described below.
Puddle Build-up Time (u)
1. While pressing the Cycle Start button, connect the power cord to an appropriate power supply.
2. The Display will show “u0.0” flashing.
3. Turn the Travel Speed Adjustment knob until the desired build-up time is displayed.
4. Default setting is 1.0 seconds. Available range is 0.0 - 9.9 seconds.
Crater Fill Time (n)
1. Press Cycle Start button once more.
2. The Display will show “n0.0” flashing.
3. Turn the Travel Speed Adjustment knob until the desired crater fill time is displayed.
4. Default setting is 1.0 seconds. Available range is 0.0 -9.9 seconds.
Pause Time (E). After welding, a brief rest before Crater Fill.
1. Press the Cycle Start button once more.
2. The Display will show “E0.0” flashing.
3. Turn the Travel Speed Adjustment knob until the desired stop time is displayed.
4. Default setting is 0.5 seconds. Available range is 0.0 - 9.9 seconds.
When finished setting times, press the Cycle Stop button to exit time setup mode. The machine is now
ready to be setup for welding.
A graphic display of the user adjustable time settings.
STOP SENSOR OPERATION
The K-BUG 1200 is equipped with two (2) Stop Sensors. One sensor is placed on the right side of the
carriage, the other is placed on the left. The Stop Sensors are normally open switches that engage or
close when depressed. If a sensor is tripped during welding, carriage travel will immediately stop and
Crater Fill will be performed. Remove the obstacle to reset the Stop Sensor. Press Cycle Start button to
begin weld cycle again. NOTE: If Stop Sensor is tripped during intermittent welding, program will reset,
NOT resume.
u E n
Travel
Weld “On”
(time)
Non-Weld
Travel