BUG-O Systems K-BUG 1200 - Manual (Page 6)

6
ILLUSTRATION OF TYPICAL APPLICATIONS
USER INTERFACE
1. Cycle Start Button - Push button to initiate
weld cycle. Weld contact will close, according to
time settings, if the Weld Switch is set to Auto,
the carriage will travel in the direction selected
by the Travel Direction Switch.
2. Cycle Stop Button - Push button to stop
welding cycle.
3. Travel Direction Switch - Set switch to
determine direction of carriage travel.
4. Speed Adjustment Dial - Rotate knob to adjust
carriage travel speed. Turning clockwise (right)
will INCREASE speed.
NOTE: Travel Speed Adjustment Knob is also
used for setting the INTERMITTENT WELDING
function (pg.7) and the time settings.
5. Weld Auto / Off Contactor - When switched to
AUTO, weld contact will close with cycle start.
Switched to the right, weld contact will remain
open upon cycle start.
6. Digital Speed Display - Numerically displays
real-time travel speed in in/min. (cm/min). Also
displays parameters during setup of intermittent
function and time settings
7. Indicator LED’s - Indicate active parameter
during intermittent welding.
A. Weld Length
B. Non-Weld Length
C. Total Length