Broadata Communications 1000E Series - Manual (Page 7)

BCI 1000E User’s Manual
Fiber Optic Serial Data Video Transport System
Broadata Technical Support, (800) 214-0222 8
2.2 Cabling and Connectors
In order to set up the BCI 1000E properly, make sure to observe
the following instructions when installing the proper cables. The
1000E requires two parts to the cabling setup: the electrical
and the optical. For the optical part, observe the following
procedures, as there are various types of optical connectors as
illustrated on the following page.
2.2.1 Electrical Cable Connection
The only available cable connections on the electrical side are
for video sources.
Proceed with the following instructions when connecting the
various electrical devices.
2.2.2 Digital Video Connection
The 1000E unit provides 75 Ohm BNC connectors for digital
video input and output ports. Use the following procedure for
connections.
1. On the near end, connect the user’s digital video source to
the 1000E-T (transmitter) unit’s digital video input port, using
a coaxial cable (i.e., Belden 8281 or better). The digital
video output port can be connected to a video monitor, using
a coaxial cable, for monitoring purposes (See Figure 2-2).
2. On the far end, connect the 1000E-R (receiver) unit’s digital
video output ports (1 to 2) to the user’s digital video receivers,
using coaxial cables. (See Figure 2-2).