Broadata Communications 1000E Series - Manual (Page 6)

BCI 1000E User’s Manual
Fiber Optic Serial Data Video Transport System
Broadata Technical Support, [email protected] 7
2.0 SETUP
The BCI 1000E Series units are used in pairs. In a unidirectional
application, a 1000E transmitter (1000E-T) is located at the near-end
and connected through one fiber to a 1000E receiver (1000E-R) located
at the far-end. In a bi-directional application, one 1000E transceiver unit
is located at the near end and connected through two optical fibers to
identical 1000E transceiver located at the far end of the link. Each unit
provides a separate electrical interface connector for the Serial Digital
Video data signals. Connections are one to one between both units.
Figure 2-1 depicts a typical installation.
Figure 2-1
1000E Setup
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and optical
cables without stressing them beyond the manufacturer’s
limitations (also known as the bend radius minimum). Rack
Mount kits are available through special order.