Broadata Communications Mini-HDMI-AD Series - Manual (Page 8)

Mini-HDMI-AD User’s Manual
Miniature Multimode Fiber Optic HDMI Transmission System
Broadata Technical Support, [email protected] 9
2.2.1.2 Audio Interface
The audio interface supports two channel high fidelity
transmissions. Two separate mono channels or one stereo
channel is transmitted in each direction. Line-level audio signals
are connected to the Mini-HDMI-AD units. The following steps
illustrate the installation procedures for audio devices.
To send audio signals, label and connect two cables to the
“AUDIO OUTPUT” connectors of the line level audio source.
On the Mini-HDMI-AD, connect the other end of the cables to
the front panel terminal block connectors labeled “AUDIO IN”.
For stereo channels, be sure to match the cables at both
ends (L to L, R to R). (See Figure 2-3a).
To receive audio signals, at the far-end location, label and
connect two twisted shielded pair cables to the “AUDIO INPUT”
connectors of the line level audio receiver. On the Mini-HDMI-AD,
connect the other end of the cables to the front panel terminal
block connectors labeled “AUDIO OUT”. If using stereo
channels, be sure to match the cables at both ends
(L to L, R to R). (See Figure 2-3b).