Broadata Communications Mini-HDMI-AD Series - Manual (Page 6)

Mini-HDMI-AD User’s Manual
Miniature Multimode Fiber Optic HDMI Transmission System
Broadata Technical Support, [email protected] 7
2.0 SETUP
The BCI Mini-HDMI-AD Series units are used in pairs. One
Mini-HDMI-AD-T transmitter unit is located at the near-end and connected
through one optical fiber, to the Mini-HDMI-AD-R receiver located at the
far-end of the link. Figure 2-1 depicts a typical installation for the
Mini-HDMI-AD-T/R.
Figure 2-1
Mini-HDMI-AD Setup
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and optical
cables without stressing them beyond the manufacturer’s
limitations (also known as the minimum bend radius).
2.2 Cabling and Connectors
In order to setup the BCI Mini-HDMI-AD properly, make sure to
observe the following instructions when installing the proper
cables. The Mini-HDMI-AD requires two parts to the cabling
setup: the electrical and the optical.