Brinly CC-560 BH Cultivator - Manual (Page 5)

1007076 Rev. A 5
ASSEMBLY
TOOLS REQUIRED:
9/16" Wrench (1)
3/4" Wrench (2)
11/16" Wrench (1)
1a. Loosely assemble Hitch Bracket
(2) to Pull Bar (3) using Plow Bolts (13),
7/16" Lockwashers (18), and 7/16" Nuts
(16) as shown. DO NOT TIGHTEN.
NOTE: It is important to orient Plow
Bolts in direction shown.
1b. Assemble Tie Strap (9) to Pull Bar
(3) using 1/2" x 1-1/2" Bolts (10), 1/2"
Lockwashers (19), and 1/2" Nuts (15).
Figure 1 HITCH BRACKET AND TIE
STRAP ASSEMBLY
(13)
Plow Bolt, 7/16" x 1-3/4"
Qty. 2
(10)
Bolt, 1/2" x 1-1/2"
Qty. 1
(10)
Bolt, 1/2" x 1-1/2"
Qty. 2
(18)
Lockwasher, 7/16"
Qty. 2
(19)
Lockwasher, 1/2"
Qty. 1
(19)
Lockwasher, 1/2"
Qty. 2
(15)
Nut, 7/16"
Qty. 2
(15)
Nut, 1/2"
Qty. 1
(15)
Nut, 1/2"
Qty. 2
2a. Assemble Frame Angles (4) to Tie Strap (9)
using 1/2" x 1-1/2" Bolts (10), 1/2" Lockwashers
(19), and 1/2" Nuts (15).
Snug but do not fully tighten at this time.
Figure 2 TIE STRAP/FRAME ANGLE
ASSEMBLY
3
16 19
9
15
10
18 2
13
10
19
15
9
4