Brinly DT-402 BH Dethatcher - Manual (Page 5)

1008565EN-B 5.
ASSEMBLY
================================================================================================
NOTE: Tines and Safety
Wires not shown.
17
17
19
17
27
19
19
7 25
8
1
13
24
14
16
19
20
16
16
19 17
20
16
17 19
Figure 1
This manual will be referencing panels of the hardware skinpack included with your dethatcher. The hardware in Panel 1A is to be used with as-
sembly step 1A; Panel 1B with Assembly Step 1B; etc.
2A) Using the hardware in Panel 2A, attach the Lift Lock (2) to the
Towbar (1) as shown in Figure 2.
Leave assembly hardware loose for this step so that tine height
can be adjusted later.
NOTE: It is important for the safety and function of the
Dethatcher that the towbar, tray and hardware be assembled
as shown in Figure 1.
2B) Assemble the hardware in Panel 2B through the Lift Lock as
shown in Figure 2. Tighten securely.
17
12
19
20
16
19
17
1
2
NOTE: Tines and Safety
Wires not shown.
3A) Pre-Assemble the Wheels (29) using the hardware in Panel 3A as
shown in Figure 3. Tighten the Nuts on the Wheels Completely.
NOTE: Observe that the Nut (18) is assembled on the hub
offset side of the wheel.
3B) Attach the pre-assembled Wheels to the Wheel Bracket (4) using
the hardware in Panel 3B.
NOTE: Use common hole locations from left to right side of
Wheel Bracket.
Note: For hitch heights
greater than eleven inches,
use the upper hole on the
Wheel Brackets (4).
15 21
29
21
18 18
18
29
4
Pre-Assembly
1A) Using the hardware in panel 1A, assemble the two towbars (1) to
the tray (8) as shown in Figure 1. Leave assembly hardware loose
in this step so that tine height can be adjusted later.
NOTE: It is important for the safety and function of the
Dethatcher that the towbar, tray and hardware be assembled
as shown in Figure 1.
1B) Using the hardware in panel 1B, assemble the Clevis (7) to the
Towbars as shown in Figure 1. Assemble all hardware hand tight.
While holding the two 5/16" Carriage Bolts (13) in the square holes
on the Clevis, tighten the 1/4" Carriage Bolt (14) and Nylock Nut
(25).
Tighten the 5/16" Nut (17) to the 5/16" Carriage Bolt (13).
Assemble the Hitch Pin (24) to the Hairpin Cotter (27) through the
Clevis.
1C) Turn the Dethatcher over so that it is resting on Tine Tips and front
of Towbars.
CAUTION: Avoid injury! Take care when handling Tray and Tine sub-assembly.
Tine tips are sharp and can cause injury.
Carefully remove Tray and Tine sub-assembly from the carton and lay fl at on working surface with tines pointing up.
Figure 2
Figure 3