Boland Communications d Series - Manual (Page 8)

Utilities Menu
Setup >
Auto Picture Setup: Auto adjust the image position, phase and size
Auto Color Gain: Auto Color Calibration (RGB white levels)
Wide Screen Mode detection : Choose to recognize the VGA mode as a
normal or wide screen input:
- Normal 4:3
- 1280x768 Widescreen
- 1366x768 Widescreen 16:9
Manual Clock : Adjust the image horizontal size
Manual Phase : Adjust image quality (fine tune the data
sampling position)
Auto Source Seek >
Setup >
Choose to display and auto detect signals for these inputs:
HD/SD SDI 1
HD/SD SDI 2
VGA
DVI
HD Component
Composite 1
Composite 2
S-Video
Note: only the names set to ON will display on the Input Select Menu.
ON: The monitor will Seek a new input if a signal is lost or missing.
OFF: Seek function is disabled (inputs will change only by manual choice)
De-interlacing Mode* >
AFM : Auto Film Mode (3:2 pull-down compliance)
TNR : Temporal Noise Reduction
MADI : Motion Adaptive De-interlacing
LADI : Low Angle De-interlacing
Auto Power > (Automatic monitor power off for missing signal; automatic power on)
ON: Enable soft power off in absence of an input signal
OFF: Disable soft power function
Video Standard (SD)* > Auto / NTSC / NTSC 4.43 / PAL / PAL M / SECAM
Image Orientation > Normal / Horizontal flip / Vertical flip / Rotate
OSD > ( On Screen Display menu system )
OSD position
H POS move the OSD menu box horizontally
V POS move the OSD menu image vertically
OSD Timeout OSD menu timeout period, 5 to 60 seconds
Note: select "0" for continuous display of OSD menu.
Transparency Sets OSD to Transparent or Opaque background.
Color Temperature > Note: settings are remembered for each input source name
5000K > (each temperature has an individual RGB submenu as shown below)
6500K > Red 0-100
8000K > Green 0-100
9300K > Blue 0-100
Default : Restore initial set of factory values.
7 V IEW P ORT Manual d series