Blu Bathworks TSP811S - Manual (Page 4)

2014-01
1 866 907 0122 blubathworks.com
®
3
811 Series Trim Installation
Refer to Fig. 1 & 2
•
Blu recommends that a test fit of all trim pieces takes place prior to securing to the valve.
•
Remove the mud guard (A) and slide the escutcheon cover plate (2) over the volume control
sleeve until the plate contacts the finished wall surface.
• Ensure the cover plate adequately covers the rough opening around the valve and that the foam
gasket fully bonds (360º) to the clean finished surface.
• Apply pressure to the escutcheon cover plate (2) ensuring a tight water-resistant connection
between the escutcheon plate (2) and the finished surface tightening the round PC threaded trim
(3).
• Place volume control handle (5) onto the rough-in spindle (C) and ensure handle is in the proper
alignment orientation. Once aligned, screw the volume control handle (5) into the rough-in (C).
Tighten with the grubbing screw (6).
•
Fit the volume control lever, tightening the set screw (7) and lever (8).
2
3 2 1
5
4
6
7
8
A
C
Fig 1.
Fig 2.