Blu Bathworks TSP811S - Manual (Page 2)

2014-01
1 866 907 0122 blubathworks.com
®
1
Attention – Before Installation
1. Inspect this product to assure you have all parts as shown that are required for proper installation (refer to
illustration 1).
2. The valve cartridge has been factory tested and adjusted – DO NOT TAKE THE CARTRIDGE APART. Taking
the cartridge apart will void the warranty.
3. The Valve body rough in depth is 1 ⅝” - 2⅛” (40-55mm) measured from the center of the inlets to the face of
the finished wall (refer to illustration 2). Note: Min/Max are located on the valve mud guard for reference
4. Ensure that both hot and cold water feeds are properly connected and to the correct side of the rough in valve
as illustrated.
5. This product must be installed by a professional contractor.
6. Refer to the specification and assembly drawings attached for installation directions.
7. Flow Pressure –Min. 25 PSI, Max. 80 PSI. Recommended pressure – 50 to 60 PSI
Installation Requirements
Please read the instructions carefully so as to avoid any damage to the fixture.
1. To ensure this product is installed properly, you must read and follow these guidelines.
2. The owner/user of the valve must keep this information for future reference.
3. This Diverter valve includes integrated service stops. Make sure the tile guard is in place and secured firmly.
4. This valve features anti scald protection. The risk of scalding exists until the installer has properly calibrated/
adjusted the temperature setting during final trim installation.
5. The supply lines must be flushed out to prevent clogging of the filter screens. Failure to flush the lines will
permanently damage the cartridge and void the warranty.
Cleaners For Fittings And Accessories
To avoid damaging the surface and working components of the fittings, certain precautions must be taken in terms
of usage and subsequent cleaning as many cleaning agents contain acids for general cleaning and removing calcium
deposits. When caring for your fittings and accessories, please note the following:
- Only apply cleaners which are expressly intended for the use
- Never use any cleaner containing hydrochloric acid, formic acid or acetic acid on or near the fitting, as they can
cause considerable damage
- Do not use cleaners containing phosphoric acid
- Do not use cleaners containing chlorine bleach solutions
- Never mix or combine cleaning agents
- Abrasive cleaners and unsuitable scouring agents such as scouring pads
Technical Support Assistance
If further assistance is required, please contact:
Product support at 1.866.907.0122 (09:00 - 17:00hrs PST) or email [email protected]
North America
Blu Bathworks Inc.
188 Smithe Street, Vancouver BC, Canada, V6B 6A9
T+1.604.299.0122 F+1.604.299.0125