Blu Bathworks BT0102 - Manual (Page 5)

4
1 866 907 0122 blubathworks.com
2015-02
INSTALL BATHTUB
• Apply a generous bead of adhesive or silicone to the bottom of the tub supports. (Fig. 6)
• Apply a bead of tub and tile caulk around the edge of the base. (Fig. 6)
• Carefully set tub into position (Fig. 7) and connect the drain hardware (previously installed).
Finish the installation of the tail piece.
PREPARE THE TAIL PIECE
All parts involved in tail piece installation are provided by the
installer (Fig. 5).
•
Waste drain must always be installed according to local
standard. Verify the placement of the bathtub before
drilling the hole for the waste drain.
• Install 1½" rubber slip gasket over the waste drain.
• Alternatively, Blu Bathworks recommends BTWaste.RN Island
Tub Drain
*** for easy installation of freestanding bathtubs.
(Provided by customer)
• Cut tail piece to desired length
(will vary for each installation)
• Slide tail piece nut over tail piece towards flanged end.
• Place flange washer on top of tail piece.
• Connect tail piece assembly to waste drain.
5
6 7
Island Tub Drain Installation ***
Refer to BTWaste.RN Installation Guide
a
a
drain body
trap
*
silicone drain gasket
on top of the tub
drain body nut
tail piece
*
Island Tub Drain
***
floor
provided by installer
*
1x pop up cover in chrome
1x pop up cover in blu·stone
™ **
silicone drain gasket
at the bottom of the tub
flat
lip
top of
the tub
bottom
of the tub
tail piece nut
included