Blu Bathworks BT0102 - Manual (Page 3)

2
1 866 907 0122 blubathworks.com
2015-02
General Instruction before Installation
IMPORTANT: Ensure to check the bathtub for proper drainage before any draining is done.
• The bathtub is shipped with the waste and matching blu·stone ™ drain cover.
• Blu recommends that the tub be water tested before installation is complete. Fill the tub to overflow and inspect for
leaks.
• Decide exactly where you wish to install the bathtub and place the tub where it is to be installed and ensure the tub is
level. Note: Use 1½" (FIP) adaptor.
• Install the basic plumbing components: water inlet and waste. These tub models require a vertical plumbing
connection from the floor.
• Shims may be required to level the tub depending on finish floor surfaces. Shims are not included. When adjusting the
level allow a slight clearance ( 8") between the finished floor and the apron. Note: use a level to ensure accuracy.
• Connect the bathtub drain to the waste. Hook up the water to the faucet. Check that all connections are waterproof.
NOTE: The faucet cannot be installed on the bathtub. The tub filler must be mounted either in the wall or a freestanding
floor-mounted tubfiller. Read the manufacturer’s instructions for installation details.