Blu Bathworks BT0102 - Manual (Page 2)

1
1 866 907 0122 blubathworks.com
2015-02
Attention — Before Installation
Thank you for choosing from among Blu’s quality line of products. We recommend that you carefully read this installation
guide to ensure your bathtub’s proper operation and reliability for many years to come.
WARNING: This bathtub is made of a quartzite stone and resin. The tub’s weight may vary between 300 and 440 lbs (140
and 200 kg). We recommend that the installation be done by a minimum of 2 people as a security precaution. Also make
sure to adopt the proper posture when lifting the tub.
Adhere to all local building and plumbing codes. The diagrams in this guide are not construction plans. They are visual aids.
Installation Requirements
Please read the instructions carefully so as to avoid any damage to the fixture.
1. To ensure this product is installed properly, you must read and follow these guidelines.
2. The owner/user of the product must keep this information for future reference.
3. Consult local building codes to make sure the installation complies with standards.
4. Remove the unit from its packaging. Before disposing of it, inspect the unit to make sure its in good shape. Should
inspection reveal any damage or defect in the finish, contact your distributor. The warranty does not cover damages or
defects in the finish once it has been installed. Blu Bathworks’ responsibility for shipping damages ceases upon delivery
of the product in good order to the carrier. All complaints regarding damage due to transport must be made directly to
the carrier.
5. Place the unit in the bathroom before you start working. Conserve all nuts and bolts.
6. To protect the unit during installation, we recommend that you lay a piece of cardboard on the bottom.
7. If the unit is covered with polyethylene protective film, do not remove until installation is complete to grant maximum
protection. However, remove film where any two surfaces will be in permanent contact.
8. Make sure the bathroom floor is level and strong enough to support the weight of the water-filled bathtub. If you are
renovating, bring down the walls to install framing and plumbing. Make sure the walls are properly insulated and comply
with the appropriate building code.
9. Verify that all dimensions on the plan are the same as the ones of the unit.
10. If an apron is to be installed, make sure the bathtub is at the same height as the floor covering.
Installation Notes
Important! Install this product according to the installation guide. Floor support under bath must provide for a minimum of
1600 lbs (725kg). Hot water supply should be 70% of capac ity or greater. Installation will vary.
Technical Support Assistance
If further assistance is required, please contact:
Product Support at 1.866.907.0122 (09:00 – 17:00hrs PST) or email [email protected]
North America
Blu Bathworks Inc.
188 Smithe Street,Vancouver, BC, Canada, V6B 6A9
T +1.604.299.0122 F +1.604.299.0125
Please refer to blubathworks.com for warranty, terms & conditions under warranty & procedure for warranty service.