Celsius to fahrenheit conversion chart, Setting the unit for remote operation – Daewoo DSB-F154LH User Manual
Page 7
6
CELSIUS TO FAHRENHEIT CONVERSION CHART
CELSIUS
FAHRENHEIT
18
64.4
19
66.2
20
68
21
69.8
22
71.6
23
73.4
24
75.2
25
77
CELSIUS
FAHRENHEIT
26
78.8
27
80.6
28
82.4
29
84.2
30
86
31
87.8
32
89.6
NOTES: • When operating the remote controller, make sure there are no obstructions between the remote
controller and the remote sensor.
• After a while the display goes blank to conserve battery power. To check the settings, press the
ON/OFF button once.
1. Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in the
remote display.
2. Make sure the
indicator appears in the remote dis-
play. Using the TEMP.
▼
or
▲
buttons, set the desired
temperature. The desired temperature can be changed up
or down 1 degree from the actual room temperature. For
temperature setting: 24~28°C
AUTO
3. Then the unit will automatically
operate.
TO SET THE UNIT TO AUTO MODE
This unit will automatically operate the unit according to its surroundings while in the Auto mode. All you have to set is
the desired temperature and it will control the fan, coolness and dehumidifier. Follow procedures below:
AUTO
1. Open the indoor unit’s cover and make sure the EMER-
GENCY/REMOTE switch
is set to the REMOTE
position; this will allow the
unit to operate with the
remote controller.
2. Press the ON/OFF button on the remote controller to turn
on the unit. The On LED will light on the indoor unit and
“ON” will light in the remote display.
To select the various modes and
settings, read the following pages.
SETTING THE UNIT FOR REMOTE OPERATION
After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation,
follow the procedures below:
THREE MINUTE COMPRESSOR DELAY
• After turning the indoor unit on and setting it for air condi-
tioner operation, the compressor (outdoor unit) will not
come on for three minutes. This is a feature that will protect
the compressor from damage due to quick start and stops.
EMERGENCY
REMOCON
EMERGENCY/REMOTE Switc
h
REMOCON
EMERGENCY
EMERGENCY
REMOTE
(DSB-18/24 SERIES)
(DSB-15 SERIES)