Changing/cleaning the air filters, Installing the remote bracket – Daewoo DSB-F154LH User Manual
Page 15
14
CHANGING/CLEANING THE AIR FILTERS
1. Open the indoor unit’s cover and remove both black
air filters by bending them slightly backward and the
lifting out.
2. Remove the two small filters (Deodorizing and
Electrostatic) from the indoor unit.
After removing the connection terminal of electric dust
collector, remove the electric dust collector.
(LH/PH/AH Model Only)
3. Examine the filters and determine if they need to be
cleaned or replaced. To clean filters, use a vacuum
and clean off dust. Use water and mild soap also if
necessary.
NOTE: The filters should be changed every 6 months.
If in a climate with cold winters, once a year is
adequate.
5. Insert cleaned or new black filters back into the unit.
4. Insert cleaned or new small filters (Deodorizing and
Electrostatic) back into the unit.
After putting the connection terminal into electric dust
collector, insert the electric dust colloctor into the unit.
(Only DSB-F154LH/154PH/154AH)
To change or clean the two black air filters, follow the procedures below:
INSTALLING THE REMOTE BRACKET
To install the remote bracket, insert one of the 2 supplied screws into top
hole of the bracket and into the wall. Level the remote bracket and insert the
other screw into the bottom hole.
Insert the remote controller when not using it.
Caution
When you remove the electric dust collector, you must remove the power plug.