Bladez Fitness Synchro GS Indoor Cycle - Manual (Page 21)

21
OPERATION PROCEDURE:
1) Installs 1 batter (3V CR2032), then the screen will display Figure A and a beep will sound.
Then the screen will display Figure B.
2) Press the MODE button to access to the set-up modes; TIME/DISTANCE/CALORIES/
PULSE. When you are in each set- up mode, for example in the time set-up mode, the time
value will blink, you can press “SET” button to adjust the value and press “MODE” for
confirmation. The set-up of DISTANCE, CALORIES & PULSE is the same as TIME.
3) When a signal is transmitted to the monitor, the value of TIME, DISTANCE, CALORIES
will accumulate as show in Figure C. If a function has been preset the target (TIME or
DISTANCE or CALORIES), will be countdown from the preset to zero. Once the target is
achieved, the monitor starts to beep for 8 seconds. Fhe function will now count up from zero
if training continues. Press “MODE” button for confirmation and skip to next set-up.
4.) In SCAN mode (shown in Figure C) RPM/SPEED/TM/DIST/CAL/PULSE will be
displayed in every 6 seconds, in the order listed above.
Figure A Figure B
Figure C