Beurer LB 50 - Manual (Page 20)

18
² If there is any water left in the appliance, pour it out.
² Use a new pad [4].
² Wash out the new pad [4] with clean water and put in the hotwater chamber.
Descaling the appliance
1 Descale the humidifier
• Never try to remove any limescale deposit with pointed or sharp
objects. This might damage the humidifier or cause it to leak.
• You should also note the manufacturer's advice for the descaling agent
which you are using.
² Use a standard commercial descaling agent.
² Fill the hotwater chamber up to the brim with descaling solution.
² Leave the descaling solution to work until the limescale has dissolved.
2
² Pour away the descaling solution. Tip the appliance sideways to remove the
descaling solution.
² Rinse out the appliance thoroughly with clean water.
After cleaning and descaling
1 Insert the pad
² Put the cleaned pad or replacement pad [4] into the hotwater chamber.
2 Assemble the appliance
² Put the steam tower [3] back into the humidifier. Press the steam nozzle [2] into
the opening at the top of the steam tower [3].
² Screw the tank catch [9] onto the water tank [8]. Place the water tank [8] in the
humidifier.
² Place the cover [1] on top of the humidifier.
Cleaning the air filter
We recommend cleaning the air filter every week.
1
² Turn the humidifier so that the air filter flap [11] at the back of the appliance is
facing you. Undo the catch on the flap and remove the air filter flap [11].
² Remove the black air filter [12] and rinse it thoroughly with clean water.
2
² Once the filter is dry you can reassemble the air filter. Insert the black air filter [12]
inside the air filter flap [11].
² Insert the two small hooks of the air filter flap [11] into the right of the air filter
opening. Press the filter flap firmly until it clicks into place.