Beurer LB 50 User Manual
Page 17

15
5 O
PERATION
1
Filling the tank
Fill the tank when putting the appliance into operation for the first time or if the red
indicator [A] is illuminated, indicating that the water level is too low.
IMPORTANT
• Only ever use fresh tap water to fill the tank.
• Never put any additives into the water.
• Make sure that the tank catch with seal on the base of the water tank is tightly
fastened before putting the appliance into operation.
² Remove the cover [1] from the humidifier.
² Pull the water tank out of the humidifier using the handles [7]. Unscrew the tank
catch [9] from the tank.
² Rinse out the water tank with clean water.
² Fill the water tank with cold tap water.
² Screw the tank catch onto the water tank. Place the water tank in the humidifier.
² Place the cover [1] on top of the humidifier.
2
Switching on the appliance
IMPORTANT
Never switch on the humidifier without the water tank or steam tower [3].
² Press the ON/OFF button [D] in order to switch on the humidifier. The green
indicator [B] is illuminated.
² Before the steam starts exiting: Rotate the steam nozzle [2] so that the steam exits
in the required direction.
After a few minutes, the appliance starts to give off steam. The green indicator [B] is
illuminated while the appliance is switched on and connected to the mains.
3
Selecting the amount of steam
²
Select the amount of steam using the steam button [C]
.
Level 1:
minimum steam (approx. 150 ml/h)
Level II:
maximum steam (approx. 400 ml/h)
After a few minutes, the appliance alters the amount of steam generated.
4
Switching off the appliance
• The appliance is suitable for continuous operation. We recommend,
however, that it is not operated for any length of time without
supervision (night operation).
• The appliance has an automatic switch-off function when the tank is
empty.
² Press the ON/OFF button [D] in order to switch off the appliance. The green
indicator light [B] goes out.