Beurer FB 50 - Manual (Page 12)

12
Vibration massage
Press the massage button (2) to switch on vibration massage. The footbath starts to vibrate. Place the
soles of your feet on the massage nubs and increase or reduce the pressure for the desired massage
effect.
Bubble massage
Press the bubble button (3) to feed air onto the bubble bar for a soothing bubble massage.
Timer
You can set the desired time (20 – 60 minutes) with the timer function. Press the timer button (4) to
extend the time another 10 minutes. The timer is factory-set to 20 minutes. The footbath switches off
automatically once the set time has expired. Maximum duration is 60 minutes. Allow the footbath to
cool for at least 15 minutes before using it again.
Temperature
The display shows the current water temperature. To change the temperature press and hold the tem-
perature button (5) until you have set the desired water temperature (35, 38, 42, 45, 48 °C). The most
pleasant temperature is in the range 35 – 42 °C, the maximum temperature is 48 °C.
The temperature is factory-set to 35 °C.
Magnetic field and infrared
The footbath has 6 magnets and 8 infrared lights integrated into the bath. They promote your circula-
tion and stimulate the reflex zones.
Massage roller
You can experience a special massage effect by moving your feet back and forth on the six massage
rollers integrated into the bottom of the footbath. The massage rollers can optionally be removed by
pulling them firmly upwards.
Removable attachments
Place the desired attachment on the holder in the centre. Press the attachment lightly down with your
foot to activate the electric motor.
The brush attachment can be used to stimulate the reflex zones in the soles of your feet
The massage attachment provides a soothing massage for your feet and promotes the circulation.
The corn and callus remover is used to remove dead skin cells and calluses.
The electric motor is protected from overheating and has a maximum load capacity. The motor stops
if it is overloaded or overheated. It can be used again after cooling down.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
• The footbath can also be used without water.
After use pour the water out over the narrow side (11) of the footbath. Do not allow water to come into
contact with the display.
6. Care and storage
After use rinse the unit with tap water. The foot bath can be cleaned with a mild, non-foaming house-
hold cleaner, e.g. neutral vinegar. To dry the air lines, switch to the bubble setting without water for
approx. 1 minute.