Beurer FB 50 - Manual (Page 11)

11
Handling
CAUTION
Switch the device off and disconnect the power supply after every use and before every clean-
ing.
• Keep the device away from high temperatures.
• Never stand in the foot bath.
• The device must not be connected to the power supply while being filled.
• Always switch the foot bath off and remove the plug from the mains socket before moving it
or cleaning it.
4. Description of footbath
1 Spray guard
2 LED display
3 Infrared light
4 Removable pedicure attachments
a Massage attachment
b Brush
c Corn and callous remover
5 Bubble bar
6 Level indicator
7 Massage roller
8 Massage-supporting footbed
9 Rubber feet (bottom of device)
10 Cord winder (bottom of device)
11 Narrow side
Display
1 button
2 Massage button
3 Bubble button
4 Timer button
5 Temperature button
7 LC display
5. Operation
Start-up
• Remove the packaging
• Check the device, power supply and cables for damage.
• Before plugging in the footbath fill it with warm water no higher than the level indicator (approx.
5 – 6 cm).
• Now plug the device into the mains power supply.
• Route the cable safely so that there is no risk of anyone tripping over it.
Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure.
Never stand up in the foot bath. The rubber feet on the base of the unit prevent it from sliding.
Switch on the footbath by pressing the button and set the desired function:
1
2
3
4 a
b
c
5
6
7
8
11
9
10
1 2 3
4 5 6