Denon AVR-2309 - Manual (Page 54)

• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is “Mode3” (vpage 43).
• Press or [OFF] and set the AVR-2309’s power to
the standby mode before disconnecting the iPod. Also switch the
input source to one to which the menu “iPod dock” is not assigned
before disconnecting the iPod.
• When using an ASD-3N or ASD-3W control dock for iPod, refer to
the respective manual to operate.
3
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “iPod/NETWORK”.
(vpage 56 “Remote Control Unit Operations”)
4 Press [MODE] and hold it down for a 2 seconds or
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, “Remote” is displayed.
[Selectable mode] Browse mode Remote mode
Display location Main unit display iPod display
Playable
files Audio file S S
Video file S z 1 Sz 2
Active
buttons
Remote
control unit
(AVR-2309)
S S
iPod A S
z 1 : When using an ASD-3N or ASD-3W control dock for iPod .
z 2 : Video may not be output, depending on the combination of
ASD-1R and iPod.
0
Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-z
one
Inf
or
mation
Tr
oubleshooting
ENGLISH
Specifi
cations
ENTER, p
ui
ENTER
[CHANNEL +/–],
[8, 9]
uip
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[iPod]
[OFF]
[1]
[2]
[6, 7]
uip
[MODE]
[TUNING+/–]
ENTER
[Front] [Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit Button only on the remote control unit [BUTTON]Symbols used to indicate buttons in this manualiPod® PlaybackThe music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-3N or ASD-3W sold separately).
The operation can also be performed using the buttons on the main
unit or remote control unit while watching the menus.iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.1 Make the necessary preparations.q Set the iPod in the DENON control dock for iPod. (vSee the control dock for iPod’s operating instructions.)
w Assign the control dock for iPod’s input. The input for the control dock for iPod is assigned to VCR by default.MENU : ”Input Setup” – “Assign” – ”iPod dock” (vpage 35)2 Either turn or press [iPod] to select the input source assigned in step 1-w above.(iPod screen)b If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.Basic OperationOK to disconnect.
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
iPod® Playback
The music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-3N or ASD-3W sold separately).
The operation can also be performed using the buttons on the main
unit or remote control unit while watching the menus.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
1
Make the necessary preparations.
q Set the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod’s operating instructions.)
w
Assign the control dock for iPod’s input.
The input for the control dock for iPod is assigned to VCR by
default.
MENU : ”Input Setup” – “Assign” – ”iPod dock”
(vpage 35)
2
Either turn or press [iPod] to
select the input source assigned in step 1-w above.
(iPod screen)
b If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
Basic Operation
OK to disconnect.