Denon AVR-2309 - Manual (Page 50)

Preparations
1
Press .
The power indicator lights red and the power is set to the
standby mode.
2 Press or [ON/SOURCE] .
The power indicator fl ashes green and the power turns on.
b Also press SOURCE SELECT when in standby mode, the power
turns on. In this case the input source is selected by remote
control unit.
b Also press [QUICK SELECT] when in standby mode, the power
turns on. In this case Quick Select is selected.
Turning the Power Off
q Press or [OFF] .
The power is set to the standby mode.
w Press .
The power indicator turns off, and so does the power.
NOTE
• Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long
periods of time or when traveling, either press
to turn off
the power, or unplug the power cord from the power outlet.
• When the multi-zone power is switched on, and you want to switch
off the main zone power, press [OFF] .
Turning the Power On
Selecting the Input Source
If “Rec Select” is selected for the input source, press
before turning .
Either turn or press [MASTER
VOLUME] .
[Variable range] – – – –80.0dB ~ +18.0dB
Operations During Playback
Adjusting the Master Volume
Press [MUTING] .
To cancel, press [MUTING] again. Muting can also be canceled by
adjusting the master volume.
Plug the headphones into the PHONES jack on the main
unit.
The sound from the speakers and pre-out connectors is automatically
cut.
NOTE
Be careful not to set the volume too high when using headphones.
Turning Off the Sound Temporarily (Muting)
Listening with Headphones
Press .
Front A Front B
Front A+B
Switching the front speakers
BAND TUNING
SHIFT
SOURCE SELECT
SHIFT
TUNING
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[TUNER]
[CHANNEL+/–]
[OFF]
[QUICK SELECT]
[ON/SOURCE]
[MASTER
VOLUME]
[MUTING]
SOURCE SELECT
TUNING
[MODE]
[MEMORY]
[TUNER]
BAND
[Front] [Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit Button only on the remote control unit [BUTTON]Symbols used to indicate buttons in this manualPlaybackSelect the source using SOURCE SELECT.Turn or press [SOURCE SELECT] to switch between input sources.NOTEThe adjustable range will differ depending upon factors such as the
type of input signal and the channel level setting.PHONES jackGet
ting StartedConnectionsSet
upPla
ybackRemote ControlMulti-zoneInf
ormationTroubleshootingENGLISHSpecifi cations
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
Playback
Select the source using SOURCE SELECT .
Turn or press [SOURCE SELECT] to switch
between input sources.
NOTE
The adjustable range will differ depending upon factors such as the
type of input signal and the channel level setting.
PHONES jack
Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-z
one
Inf
or
mation
Tr
oubleshooting
ENGLISH
Specifi
cations