D-Link DGE-500SX - Manual (Page 11)

10
LOAD C:\NWSERVER\NBI.NLM
LOAD C:\NWSERVER\MSM.NLM
LOAD C:\NWSERVER\ETHERTSM.NLM
LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_802.3
NAME=DLKGE_1_E83
BIND IPX DLKGE_1_E83 NET=xxxx
LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_802.2
NAME=DLKGE_1_E82
BIND IPX DLKGE_1_E82 NET=xxxx
LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_II
NAME=DLKGE_1_EII
BIND IPX DLKGE_1_EII NET=xxxx
LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_SNAP
NAME=DLKGE_1_ESP
BIND IPX DLKGE_1_ESP NET=xxxx
6. Restart the server again.
Parameters supported by the DLKGE.LAN driver
SLOT 1 – Forces the driver to search for the specified card.
FULLDUPLEX – The FULL-DUPLEX parameter causes the DLKGE to operate in full-duplex mode. When
operating in full-duplex mode, the DLKGE can simultaneously transmit and receive packets.
AUTONEGOTIATE – The AUTO-NEGOTIATE parameter causes the DLKGE to auto negotiate the duplex
mode and link speed with the device being connected.
TXDMATHRESHOLD – The TXDMATHERESHOLD determines the I/O method used to move transmit
packets from host memory to the DLKGE memory. The valid range for the TXDMATHRESHOLD is 0 -
1514. the default value is 800.
DISABLERXIP – Disables the DLKGE TCP/IP Receive Packet checksum support. By default, the DLKGE will
perform TCP/IP checksum verification on received packets in hardware if the operating system supports
this capability.
Due to the large number of Network Operating Systems (NOSs) supported, detailed driver ‡ software installation
instructions are given in README.TXT files on the DGE-500SX Software Diskette/CD-ROM. Review the root
directory README for overview information. For detailed installation instructions see the README and
referenced instruction files in the subdirectory corresponding to your network operating system.
‡ Check http://www.dlink.com periodically for driver upgrades.