Dip switch – Bematech KC-4112 Rev.1.1 User Manual
Page 18
User’s Manual
18
Chapter 5
Dip Switch
Dip Switch
Dip Switch
Dip Switch
Dip Switch
One set of dip switches are mounted in the control board of the KC-4112. To access these dip switches, please
do as follows:
• Turn off the printer.
• Remove the paper from the mechanism.
• Remove the two screws that hold the cover of the control board.
• Using the tables below, change the configuration of the dip switches.
• Mount the cover of the control board and fasten both screws back.
Dip Switch
Function
1
Reserved
2
PNE
On: activated
Off: not activated
3
Baud Rate
On: 19200 bps
Off: 9600 bps
4
Stop Bits
On: 1 stop bit
Off: 2 stop bits
5
Character
On: 7 bits
lenght
Off: 8 bits
6
Parity Select
On: Odd
Off: Even
7
Parity
On: not used
Off: used
8
Presenter
On: activated
Off: not activated