Bematech KB-1800 - Manual (Page 19)

19
U
S
e
R
’S
MANU
A
l KB
-1800
·
R
evision 1.3
Chapter 5
Dip Switch
One set of dip switches is mounted in the control board of the KB-1800. To access these dip switches, please do
as follows:
• Turn off the printer
• Remove the paper from the mechanism
• Remove the screws that hold the cover of the control board
• Using the tables below, change the configuration of the dip switches
• Mount the cover of the control board and fasten the screws back
Dip Switch Function
1 Baud Rate On: 115200 bps *****
Off: 9600 bps *
2 PNE On: activated **
Off: not activated
3 Reserved Must be in off position
4 Stop Bits On: 1 stop bit *
Off: 2 stop bits
5 Character leght On: 7 bits
Off: 8 bits *
6 Parity Select On: Odd
Off: even *
7 Parity On: not used *
Off: used
8 Presenter On: activated ***
Off: not activated ****
* Default
** ON - Default or :
After esc m: PNe sensor is returned in status bit (serial or USB) or Pe line (Parallel)
After esc l: Presenter sensor is returned in status bit (serial or USB) or Pe line (Parallel)
OFF - Default or after esc m: always return paper ok
After esc l: always return paper ok
*** Default for printers with presenter
**** Default for printers without presenter
***** If you set 115200bps for baud rate, you must change the dip switch 4 to OFF position, using 2
stop bits for your setup. The spooler driver is setup for 2 stop bits