Enclosed drawers for tables with channel frame, Assembly instructions – Belshaw Adamatic Sugaring Table User Manual
Page 3

3
Enclosed Drawers for Tables with Channel Frame
ASSEMBLY INSTRUCTIONS
(continued on Page 4)
Which set of holes to
use on each bracket
assembly…
…depends on your
table’s edge. Match the
tabletop edge with the
relevant holes on bracket
assemblies.
bracket
assembly
Step 3 - Attach bracket assemblies (created in Step 2) to table channels, using screwdriver.
PLEASE NOTE: Do NOT tighten screws.
Step 4 - Attach drawer enclosure to bracket assemblies.
left-hand side shown
left-hand
bracket/slide
assembly
right-hand
bracket/slide
assembly
NOTE: For 36˝ tables, use
2nd slot from front on bracket.
This will extend drawer to the
front of the table.
Drawers #501572, 502943, 502946, 502947, 502971 and 502972
Item #2 screw
Item #3 screw
(
outside enclosure)
Item #4 hex nut
(
inside enclosure)