Delta AP200 - Manual (Page 9)

OPERATING CONTROLS
ON/OFF SWITCH
The Air Cleaner is equipped with an in-line rocker switch
(M) Fig.11, located on the power cord (N). To start or
stop the motor, press downward on the rocker switch.
NOTE: The switch has markings on the side to
determine the on/off position. We suggest that when
finished with the air cleaner, the switch be turned off
rather than unplugging the unit.
Fig. 11
M
N
OPERATIONS
1. NOTE: The air cleaner may produce a slight odor for
the first couple hours of operation due to the protective
coating which is applied to internal components. This
odor will dissipate and should be disregarded.
IMPORTANT: Never operate the air cleaner without
air filters in place.
2. Fig. 12 illustrates the air cleaner being used in bench-
top sanding applications.
Fig. 12
Fig.13
Fig.15
3. Fig. 13 illustrates the air cleaner being used in circular
saw applications.
4. Figs. 14 and 15 illustrate the air cleaner being used
in dry wall and basement cleaning applications.
CAUTION: We recommend that the air cleaner be
clamped, as shown, if using sawhorses as a supporting
surface.
Fig.14
9