Delta 43-424 - Manual (Page 11)

11
Fig. 24
Fig. 25
Fig. 26
Fig. 27 Fig. 28
ASSEMBLING GUARDS
TO FENCE BODY
1. Assemble guard bracket (A) Fig. 24, and hex rod (B)
to upright hex shaft (C) as shown.
2. Assemble two guard brackets (A) Fig. 25, and clear
plastic guard (D) to holddown (E) as shown.
3. Assemble holddown/clear plastic guard assembly to
hex rod (B) as shown in Fig. 26.
4. Assemble guard bracket (A) Fig. 27, and spring
clamp (F) to hex rod (B) as shown, then tighten all wing
nuts.
5. The spring guard (F), holddown (E) and clear plastic
guard (D) can be flipped up out of the way as shown in
Fig. 28, by lifting up on locking lever (G), when not in use
or when making adjustments. CAUTION: When the
guard assembly is in the down position as shown in
Fig. 27, make certain locking lever (G) is in the locked
position as shown.
C
A
B
A
D
E
A
B
G
B
A
F
G
D
E
F