Beisler 1500-70-2 - Manual (Page 39)

2-15
OUT F6
STOP
PRG
0
STEP
100
STEP
IMPULS AM ENDE DES SCHRITTES
A programming is shown for the example of output F6 (displayed in the upper
left corner of the display).
A function must be selected for each input/output, a start delay and duration
must be programmed. The selected function is displayed on the left side in
front of the background „I/O“. The icons will be explained further below.
The start delay is displayed to the right of the left-handed „hour glass“, the
active duration to the right of the right-handed hour glass. The avilable
functions are displayed above the hour glasses in a horizontal row.
Do the following to program an input or output:
1. Position the cursor on the icon of a function in the upper right part of the
display.
2. Press the horizontal arrow keys until the desired function icon is marked.
3. Press the Plus key to select the marked function icon. It will be displayed
in the area „I/O“.
4. Position the cursor on the time value to the right of the left-handed hour
glass icon if you want to program a start delay (in ms) for the selected
function.
5. Press the Plus/Minus key repeatedly, until the desired value is displayed.
6. Position the cursor on the time value to the right of the right-handed hour
glass, where you can program the active time (in ms) for the selected
funtion.
7. Press the Plus/Minus key repeatedly, until the desired time value is
displayed.
8. Press the Special key to leave the setup page and store the changes.
9. Repeat this procedure for all inputs and outputs which you want to modify.
3.7.2 Settings for this machine
The inputs and outputs at this machine should be programmed as follows:
Inputs
Safety switch for thread cutter
M1
STEP
Switch for tape cutter
M2 Fn F6 ON
Outputs
Pinking mechanism, pressure 3 bar