Beisler 1281-5 - Manual (Page 21)

5.6 Adjusting the fullness of needle and bottom feed
Operator terminal in case of fullness adjustment Operator terminal in case of fullness
adjustment via step motors
via cylinder (optional equipment)
Needle feed, bottom feed and puller feed can be adapted to the sewing
conditions with the dials 1 and 2.
Via the control parameters you can determine which feed is changed
with the dial 2.
Adjusting the puller feed
–
Set the dial 1 correspondingly.
Setting range:
+ 0 to 6 right
- 0 to 6 left
Adjusting the needle and bottom feed
–
Make the corresponding settings in the control in the menu
“Seam-specific parameters”.
– Set the dial 2 correspondingly.
Setting range:
+ 0 to 6 right
- 0 to 6 left
17
1
1 2 1