BECKHOFF M1410 - Manual (Page 9)

M1410 Parallel Input / Output Beckhoff II/O-System
Date : 2.8.94 Version : 2.0 Page 9 of 14
The following module configuration is possible by setting jumpers 3 to 6:
Fast Inputs M1410 (Interrupt Inputs)
Jumper 3 Fast input II3 :
If jumper connection betwenn port D0.3 and XILINX II3 is
established Fast input is ativated
Jumper 4 Fast input II2 :
If jumper connection betwenn port D0.2 and XILINX II3 is
established Fast input is activated
Jumper 5 Fast input II1 :
If jumper connection betwenn port D0.1 and XILINX II3 is
established Fast input is activated
Jumper 6 Fast input II0 :
If jumper connection betwenn port D0.0 and XILINX II3 is
established Fast input is activated
Power Supply
There are the following connections for power Supply :
(1) two pole plug connection for the controller (X10 Pin1+2)
(2) two pole plug connection for outputs (X20 Pin1+2)
( 16 outputs )
(3) two pole plug connection for inputs X21 Pin1+2)
(16 inputs)
(4) two pole plug connection for ground (X22 Pin1+2)