BECKHOFF M1410 - Manual (Page 7)

M1410 Parallel Input / Output Beckhoff II/O-System
Date : 2.8.94 Version : 2.0 Page 7 of 14
4. Installation
The M1410 is connected to the fibre optic ring using fibre optic connections (Toshiba). The
maximum length of the FO cable, leading to the neighbouring boxes, should not be more then
600m for glass fibre or 45 meters for other fibres. These values are only valid, if for bending
the cable a radius of at least 30 mm is used. If there are no glass fibres used, no special tools
are needed for installation of the plugs.
Common actors and sensor are connected directly to the inputs / outputs (using "+,-,signal" ).
The M1410 is installed at the machine or simply by installing it to a cartridge carrier
according to DIN EN 50022 or DIN EN 50035.
Configuration
Each I/O port of the M1410 can be configured as input or as output. This does not depend on
the configuration of the other ports. There are DIP switches under the XILINX board of the
M1410. In order to change the state of the switches the module’s cartridge has to be opened..
The DIP switches are assigned as follows:
switch 1 => port D0
switch 2 => port D1
switch 3 NC, no connectet, set to ’ON’
switch 3 NC, no connectet, set to ’ON’