BECKHOFF CB3053 - Manual (Page 24)

Chapter: Connectors LVDS
page 24 Beckhoff New Automation Technology CB3053
4.8 LVDS
The board also offers the possibility to use displays with LVDS interface. These can be connected via a
30 pin flat-cable plug (JAE FI-X30S-HF-NPB, mating connector: FI-X30C(2)-NPB). Only shielded and
twisted cables may be used. The display type is to be chosen over the BIOS setup. The connector has
two additional shield pins S1 and S2 which are omitted in the pinout table below.
Pinout LVDS connector:
Pin Name Description
1 TXO00# LVDS even data 0 -
2 TXO00 LVDS even data 0 +
3 TXO01# LVDS even data 1 -
4 TXO01 LVDS even data 1 +
5 TXO02# LVDS even data 2 -
6 TXO02 LVDS even data 2 +
7 GND ground
8 TXO0C# LVDS even clock -
9 TXO0C LVDS even clock +
10 TXO03# LVDS even data 3 -
11 TXO03 LVDS even data 3 +
12 N/C reserved
13 N/C reserved
14 GND ground
15 N/C reserved
16 N/C reserved
17 GND ground
18 N/C reserved
19 N/C reserved
20 N/C reserved
21 N/C reserved
22 N/C reserved
23 N/C reserved
24 GND ground
25 3.3V 3.3 volt supply
26 DDC_CLK EDID clock for LCD
27 DDC_DAT EDID data for LCD