Directed Electronics G38106 - Manual (Page 7)

FLUSH MOUNTING INTO REMOVED PANELS
Step 1: Determine the tweeter mounting location, then route the
wires from the crossover to the tweeter location.
Step 2: Mark the center point of the tweeter location.
Step 3: If using a hole saw, first drill a pilot hole, then cut out the
hole using a standard 2-1/8" hole saw.
Step 4: If not using a hole saw, use either the cardboard packaging
for the tweeters or the surface mount trim ring as a template
to mark the proper size hole. Cut out the hole.
Step 5: With the tweeter assembled, route the wires through the
hole and the pressure ring and slip the pressure ring over
the tweeter assembly.
Step 6: Align the tweeter so the logo faces the desired direction
then push the pressure ring on to the rear of the tweeter
assembly until the tweeter is snugly mounted to the panel.
Step 7: Connect the speaker wires observing the correct polarity
and re-assemble the panel.
TWEETER PANEL
SURFACE MOUNT HOUSING
WIRING HARNESS
SURFACE
MOUNT
TRIM RING
TWEETER WIRE
MOUNTING SCREWS
6