Directed Electronics G38106 - Manual (Page 4)

REAR DECK MOUNTING
In rear deck installations, check the operation of the trunk
suspension springs or tension bars. These tension bars can move
when opening and closing the trunk and can exert a great deal of
force against anything that obstructs their movement, such as a
speaker basket or motor assembly. In addition, try to avoid locating
the speakers too close to the back edge of the rear deck. Installing
the rearmost screws may not be possible without the removal of the
rear window.
INSTALLING THE MIDRANGE
Step 1: Determine where the speaker will be mounted. Make sure
there is a flat area large enough for the speaker to fit
properly. An uneven mounting surface can damage the
driver and limit the bass performance of your PC
component system.
Step 2: Check to make sure the mounting location you have chosen
for the speaker will not interfere with the operation of the
vehicle.
Step 3: Using the supplied template guide, mark the hole with a pen.
Step 4: [Skip this step if using correctly sized factory locations] Cut
the hole for the speaker. A hole can be cut either with a
pair of metal tin snips, an air or jig saw, or with a hole saw
corresponding to the size of the woofer listed below.
• 4¾” Hole Saw (5¼” woofer installation)
• 5¾” Hole Saw (6½” woofer installation)
WARNING: Window mechanisms and electrical wires and other
expensive car parts have a nasty habit of hiding where you
least expect. CHECK BEFORE YOU DRILL!
Step 5: Run the speaker wire to the speakers. Make sure to keep
wires away from sharp metal or other edges. When passing
through metal, use a protective grommet.
3