BECKHOFF C9900-U3x0 - Manual (Page 18)

Technical data
Memory allocation in the DPRAM
The mentioned address means the offset from the base address of the CP
link card (e.g. CP link card on &HCC00:0000, loading controller on
&HCC00:03ED). Take care about the configuration of the PC, to avoid
overlapping with other PC cards.
Loading controller 0x03ED UPS status
Waiting Loaded No power pack Loading
Power
pack volt. Ext.
supply OK
0x03EC UPS control active
Layout of the UPS interface card C1230S
System-Bus
USV
Fronttableau
1 ST701
ST1000
1 ST702
1 ST703
The charging system
An integrated charger ensures that the battery is always kept fully charged.
The charging current is 1/3 of the full capacity, i.e. about 200-800 mA. The
charging procedure therefore takes up to 4 hours, depending on the charge
already in and the aging of the battery. Overcharging, and consequent
damage to the battery, is prevented through the use of an integrated
charging controller.
Pin assignment ST 703 UPS
PIN Signal PIN Signal PIN Signal
1 PA0 10 PCL1 19 PB6
2 PA1 11 PCL2 20 PB7
3 PA2 12 PCL3 21 PCH0
4 PA3 13 PB0 22 PCH1
5 PA4 14 PB1 23 PCH2
6 PA5 15 PB2 24 PCH3
7 PA6 16 PB3 25 +5V
8 JUMP 17 PB4 26 GND
9 PCL0 18 PB5
C9900-U3x0 15