BECKHOFF C9900-M298 - Manual (Page 8)

Inserting the Control Panel
Once the wall mounting frame is installed in the wall and the brackets are
attached to the Control Panel, the Control Panel can be inserted in the
frame:
Position the Control Panel, First position the Control
Panel with the mounting
bracket on the lower edge of
the mounting frame.
Now connect all electrical
connections at the rear of the
Control Panel.
Warning
Follow the connection instructions for the respective Control Panel.
engage the fastening
bracket
Now tilt the Control Panel
back. Push the fastening
bracket down slightly, so that
it can engage below the upper
edge of the mounting frame.
The Control Panel is now
secure and cannot detach
itself from the frame.
and tilt the Control Panel
back
Now move the Control Panel
into its final position. The
Panel is now held securely in
position through the pre-
assembled fastening
magnets.
Finally check the Control
Panel for secure fastening in
the frame.
Dismounting the Control Panel
Dismounting in reverse
order Dismounting the Control Panels occurs in reverse order:
1. Grasp carefully behind the upper edge of the Panel in order to
solve the chassis of the fastening magnets.
2. Swivel out the Panel so far as the fastening bracket allows.
3. Push down the fastening bracket a bit in order to swivel out the
Panel completely.
4. Disconnect all connections to the Panel.
5. Take out the Control Panel from the wall mounting frame carefully
and put it down on a clean, soft base.
6 C9900 wall mounting frame