BECKHOFF C9900-M298 - Manual (Page 7)

Attaching the brackets to the Control Panel
In order to be able to fasten the Control Panel in the wall mounting frame,
the fastening bracket and the mounting bracket first have to be attached to
the Panel. Proceed as follows:
Attaching the fastening
bracket
Remove the clamping lever
located at the top in the center
of the Control Panel using a
2.5 mm Alleen key. For a
CP6608 Panel remove the top
left or right clamping lever.
Attach the fastening bracket in
place of the clamping lever
using the M4 x 5 mm screw
provided as shown.
Mounting - CP6608 shown as example
Warning
When removing the clamping levers prevent the Control Panel from
disintegrating while the bolts are removed.
Attaching the mounting
bracket
Then remove the three lower
clamping levers (two levers
for CP6608).
Attach the mounting bracket
in place of the clamping lever
using the remaining
M4 x 5 mm bolts as shown.
C9900 wall mounting frame 5