BECKHOFF CU8890-0000 - Manual (Page 35)

Software installation
Windows CE
Windows CE Under Windows CE the operation of the CU8890 WLAN-Controller is only
possible in client mode.
The Windows CE driver is available for CE 6. You can download the driver
for Beckhoff x86- and ARM based devices under
:
ftp://ftp.beckhoff.com/Software/embPC-
Control/CE/Solutions/CUxxxx_Driver/CU8890_CE60.zip
For operating the CU8890 WLAN-Controller you need the CE driver as well
as the Microsoft Zero tool for configuration the WLAN. On x86 based
devices this is already integrated in the CE 6 image. On ARM based
devices the installation has to be started later on.
Proceed as follows:
Driver Installation on ARM based Devices
ARM based devices
Proceed as follows to install the drivers:
1. Download and unpack file CU8890_CE60.zip.
There are two sub-folders for the particular systems x86 or ARM.
2. Copy the files of the selected system (x86 or ARM) to the CE
device (via USB stick, public folder or FTP folder)
3. Copy the files to the correct folders:
\Hard Disk\System:
xcopy all files to device under \hard disk\System
\Hard Disk\RegFiles:
xcopy all files to device under \hard disk\Regfiles
4. Double click on all new Registry Files
5. Finally reboot the system.
After rebooting the system, the driver is installed, as well the Microsoft Zero
Tool at ARM based devices.
Connecting with the network
Connecting with the
network In the graphical user interface you can select a network. Click connect to
connect with the network:
CU8890-0000 33