BECKHOFF CU8860-0000 - Manual (Page 8)

Installation
CU8860-0000 6
3 Installation
3.1 Installing USB cable strain relief
All plugs, connected to the unit, have an integrated stain relief, except the USB plug. To provide the USB plug from
disconnecting, a bracket must be installed on the front of the unit. The bracket has the following measures:
The bracket is fixed with a screw (M3, 4 mm). The USB plug will be connected to the unit. The cable is place
through the slot in the middle of the bracket. (see picture)
3.2 Mounting / Unmounting
The USB-Extender-RX CU8860-0000 can be installed in two ways. There are two versions of mounting kits to
install the unit (a) onto a planar surface or (b) onto a 35 mm mounting rail that conforms to EN 50022.
3.2.1 Mounting on a planar surface
First the installation on planar surfaces is described. The kit has the following measures: